AC3 Passthrough with audigy 2zs

Catscrash · Jan 5, 2007, 04:19 PM

hi, my problem is, that always when i click on "pass through" in the mixer, there is no sound any more at all, and when i dont, my receiver doesnt recognise DD or DTS signal...
so, what can i do that my audigy 2 ZS just sends the undecoded ac3-signal to my receiver like every stupid on-board-soundcard does?!

thank you very very much
Catscrash

Catscrash · Jan 5, 2007, 04:49 PM

hmm, i installed the new version, set the drop down list with AC3 and the two arrows to SPDIF 0, unchecked the SPDIF-thing on the right side which says "SPDIF ByPass-Mode umschalten" and now it works... thanks :>

MacGyver2k · Nov 13, 2007, 09:21 PM

hi,

i just searched the forums but didn't find anything usefull for me.
i reinstalled windows this weekend and used the 5359 drivers. everything worked fine until today when i tried to passthrough ac3 to my receiver. i checked spdif0 and "toggle digital output only mode" and my receiver just didn't receive a signal.
so i uninstalled and tried 3838k / 3538l / 3538m - same effect.

so i checked what version i had installed before and fount out it was 3538i. after installing it everything works fine again. i am using an audigy2zs ( SB0162 10k2 ).
maybe i forgot to check some options but i don't think so.
i configured it for redocneXk everything should be right ??? any ideas ?

thanks.

Jan 5, 2007, 04:19 PM	#1
Catscrash DriverHeaven Newbie Join Date: Jan 2007 Posts: 2 Rep Power: 0	AC3 Passthrough with audigy 2zs hi, my problem is, that always when i click on "pass through" in the mixer, there is no sound any more at all, and when i dont, my receiver doesnt recognise DD or DTS signal... so, what can i do that my audigy 2 ZS just sends the undecoded ac3-signal to my receiver like every stupid on-board-soundcard does?! thank you very very much Catscrash

Jan 5, 2007, 04:49 PM	Thread Starter #2
Catscrash DriverHeaven Newbie Join Date: Jan 2007 Posts: 2 Rep Power: 0	hmm, i installed the new version, set the drop down list with AC3 and the two arrows to SPDIF 0, unchecked the SPDIF-thing on the right side which says "SPDIF ByPass-Mode umschalten" and now it works... thanks :>

Nov 13, 2007, 09:21 PM	#3
MacGyver2k DriverHeaven Newbie Join Date: Oct 2004 Posts: 2 Rep Power: 0	hi, i just searched the forums but didn't find anything usefull for me. i reinstalled windows this weekend and used the 5359 drivers. everything worked fine until today when i tried to passthrough ac3 to my receiver. i checked spdif0 and "toggle digital output only mode" and my receiver just didn't receive a signal. so i uninstalled and tried 3838k / 3538l / 3538m - same effect. so i checked what version i had installed before and fount out it was 3538i. after installing it everything works fine again. i am using an audigy2zs ( SB0162 10k2 ). maybe i forgot to check some options but i don't think so. i configured it for redocneXk everything should be right ??? any ideas ? thanks.