Problems Recording With EMU APS

craigcw · Jan 18, 2008, 05:56 AM

I am not able to record into Soundforge or any wave editor with my EMU APS. The sound source is going through the card and is heard over the speakers, but when I try to record into Soundforge, there is no audio coming in. I have tried every routing I can see on the KX mixer, and nothing solves this problem. Any suggestions/solutions?

Russ · Jan 31, 2008, 03:06 AM

It depends on what the audio source is, and your DSP config, etc.

With the default DSP config:

Adjust the Master Recording Level on the Recording page of kxmixer (or leave at default value of 100).

For kX Synth Recording:
- Adjust the Synth Recording Level slider on the Recording page of kX Mixer.

For Wave Recording:
- Adjust the Wave Recording Level slider on the Recording page of kX Mixer.

For Line In or MIC In Recording:
- Adjust the AC97 Recording Level slider on the Recording page of kX Mixer.
- Select MIC or Line In as the AC97 source (dropdown box) on the AC97 page of kxmixer.
- Make sure that the Analog Recording Gain slider on the AC97 page of kxmixer is not muted (inF). Adjust the Gain as desired.

Also, make sure that kX Wave 0/1 is set as the default device for audio playback and recording in the Windows Control Panel or within your software if it allows you to specify which device to use.

Jan 18, 2008, 05:56 AM	#1
craigcw DriverHeaven Newbie Join Date: Jan 2008 Posts: 1 Rep Power: 0	Problems Recording With EMU APS I am not able to record into Soundforge or any wave editor with my EMU APS. The sound source is going through the card and is heard over the speakers, but when I try to record into Soundforge, there is no audio coming in. I have tried every routing I can see on the KX mixer, and nothing solves this problem. Any suggestions/solutions?

Jan 31, 2008, 03:06 AM	#2
Russ HardwareHeaven Extreme Member Join Date: Jan 2005 Posts: 5,563 Rep Power: 62	It depends on what the audio source is, and your DSP config, etc. With the default DSP config: Adjust the Master Recording Level on the Recording page of kxmixer (or leave at default value of 100). For kX Synth Recording: - Adjust the Synth Recording Level slider on the Recording page of kX Mixer. For Wave Recording: - Adjust the Wave Recording Level slider on the Recording page of kX Mixer. For Line In or MIC In Recording: - Adjust the AC97 Recording Level slider on the Recording page of kX Mixer. - Select MIC or Line In as the AC97 source (dropdown box) on the AC97 page of kxmixer. - Make sure that the Analog Recording Gain slider on the AC97 page of kxmixer is not muted (inF). Adjust the Gain as desired. Also, make sure that kX Wave 0/1 is set as the default device for audio playback and recording in the Windows Control Panel or within your software if it allows you to specify which device to use.