MX6 Mixer

Steve Wellens · Feb 23, 2011, 02:11 AM

I'm using the 64-bit version: 5, 10, 00, 3550 - debug

The documentation for MX6 mixer describes the checkboxes like this:

-M checkbox Routes to MAIN BUS
-R checkbox Routes to REC BUS
-X checkbox Mutes the channel's Input

However the checkboxes are labeled:
-M
-R
-E

What does E do and stand for? (Thanks!)

Russ · Feb 23, 2011, 02:24 AM

IIRC, 'E' enables/disables that input.

[Edit]
Just found one of my old posts about MX6:

Quote:

The Enable (E) button enables/disables that channel.
The Main (M) button toggles whether that channel is sent to the Main outputs.
The Record (R) button toggles whether that channel is sent to the Rec (recording) outputs.
The Volume slider for each channel controls the volume level of that channel.
The Pre Fader Rec (PFR) button toggles whether or not a channels volume slider is applied to the signal going to the Rec outputs.
The Main and Record volume sliders adjust the final level for those outputs.
The SWAP button swaps the Main and Rec outputs.

Steve Wellens · Feb 23, 2011, 02:33 AM

Ah....
Before checking it muted it.
Now, checking it enables it.

No wonder I was confused (well that's one reason anyway).

Feb 23, 2011, 02:11 AM	#1
Steve Wellens HardwareHeaven Junior Member Join Date: Dec 2008 Posts: 24 Rep Power: 0	MX6 Mixer I'm using the 64-bit version: 5, 10, 00, 3550 - debug The documentation for MX6 mixer describes the checkboxes like this: -M checkbox Routes to MAIN BUS -R checkbox Routes to REC BUS -X checkbox Mutes the channel's Input However the checkboxes are labeled: -M -R -E What does E do and stand for? (Thanks!) __________________ Steve Wellens

Feb 23, 2011, 02:33 AM	Thread Starter #3
Steve Wellens HardwareHeaven Junior Member Join Date: Dec 2008 Posts: 24 Rep Power: 0	Re: MX6 Mixer Ah.... Before checking it muted it. Now, checking it enables it. No wonder I was confused (well that's one reason anyway). __________________ Steve Wellens