Output routing ...

jiiteepee · Feb 21, 2006, 08:12 PM

Hi

Does kX drivers allow you to route the stereo output to all Audigy 2 analog stereo channels (3) simultaenously so the levels are equal and no loss of frequencies (I'm thinking 'bout ability to playback from audio player (winamp, foobar) to 3 (4th (headphones) would be the output from J1) devices simultaenously using kX_ASIO)?

This can be done with CT drivers though, but you need to make some settings before it's possible (speaker /CMMS 3D settings).

jiitee

joat · Feb 21, 2006, 10:28 PM

assuming luck is on my side this may be what you mean

here is a DSP routing i use, its ultra basic and i have mapped the windows output to all outputs of the sound card going thru a st vol first so you can adjust levels if needed

I also have a signal generator in there so I can Identify one speaker at a time if needed
so FXbusx 0/1 >> StVol >> k2lt (or k1kt depending on CL card) out 1-10 or whatever you want

I dont use physical inputs at the moment so they are not catererd for. i only use the outputs.

**dj_stick** · Feb 22, 2006, 10:01 AM

fyi, the headphones output on the J1 connector is the same signal as the front (green) output (also the swap front/rear option in kX has no effect on this output)

Feb 21, 2006, 08:12 PM	#1
jiiteepee HardwareHeaven Senior Member Join Date: Apr 2005 Location: FI Posts: 400 Rep Power: 0	Output routing ... Hi Does kX drivers allow you to route the stereo output to all Audigy 2 analog stereo channels (3) simultaenously so the levels are equal and no loss of frequencies (I'm thinking 'bout ability to playback from audio player (winamp, foobar) to 3 (4th (headphones) would be the output from J1) devices simultaenously using kX_ASIO)? This can be done with CT drivers though, but you need to make some settings before it's possible (speaker /CMMS 3D settings). jiitee

Feb 21, 2006, 10:28 PM	#2
joat DriverHeaven Junior Member Join Date: Feb 2006 Posts: 36 Rep Power: 0	assuming luck is on my side this may be what you mean here is a DSP routing i use, its ultra basic and i have mapped the windows output to all outputs of the sound card going thru a st vol first so you can adjust levels if needed I also have a signal generator in there so I can Identify one speaker at a time if needed so FXbusx 0/1 >> StVol >> k2lt (or k1kt depending on CL card) out 1-10 or whatever you want I dont use physical inputs at the moment so they are not catererd for. i only use the outputs. __________________ AMD 3800 64 2X 939, 1gb ddr400, WD 36GB SATA 10k rpm, 200 & 2x 300 GB seagate sata, ATI 9600 256mb, audigy 2 zs. http://www.davethedog.co.nz