|
|||||||
| Hardware Discussion & Support Discuss your computer - its components or ANY hardware, past/current/future you want, or ask our forum experts if you have a general problem with your hardware. |
![]() |
|
|
Thread Tools |
|
|
#1 |
|
HardwareHeaven Lover
Join Date: Oct 2004
Posts: 119
Rep Power: 0 ![]() |
hard drive jumper settings
i just got my first SATA hard drive and the jumper settings are
1. Default 2. SCC (spread spectrum) 3. PM2 4. OPT1 kinda different from master, slave and cable select....i dont know which one to use.... |
|
|
|
|
|
#2 |
|
HH's Nokia shareholder!
|
What drive you got there? The only jumper settings that I've seen have been on Seagate drivers for selecting the SATA mode, I or II ...
|
|
|
|
|
|
#3 |
|
Member
Join Date: Mar 2003
Posts: 5,989
Rep Power: 71 ![]() ![]() ![]() ![]() |
|
|
|
|
|
|
#4 | |
|
Obvious Closet Brony Pony
|
use what came with your drive from factory... (default)
if it came with a jump, leave it where it was.. if it didn't... don't put one in the spread spectrum is to lower "interfeerance" between devices. the only time you need to use the 150MB/s mode is if you want to use it on a board that is SATA1 only and doesn't work with a sata 2 drive properly.
__________________
Quote:
|
|
|
|
|
|
|
|
|
HardwareHeaven Lover
Join Date: Oct 2004
Posts: 119
Rep Power: 0 ![]() |
so just leave it at default....but what does spread strectrum do though? I've just read the wiki on it partially, i dont get what it does for the hard drive...
|
|
|
|
|
|
#6 | |
|
Obvious Closet Brony Pony
|
__________________
Quote:
|
|
|
|
|
|
|
#7 | |
|
Neighborhood screw up.
|
Quote:
__________________
![]()
|
|
|
|
|
![]() |
| Thread Tools | |
|
|