I just recently changed my drivers over to the mobility set because of some input lag issues (I had recently been using a DHTool Modded catalyst set). Theres a few little tiny problems I'm having.
First of all -- I usually have my computer outputted to my TV. I have theater mode set up for movies, etc. The problem I'm having is that sometimes I watch anime with subtitles, and sometimes widescreen movies, and when I go to the catalyst control center to adjust the position of the TV screen -- the adjustments have no effect. So to be specific, say I pop open a wide screen movie, it goes full screen to my TV, then I notice that its a bit too stretched. So I go into CCC and to the TV property adjustments -- and althought it lets me adjust, they have no effect. On my far back previous drivers (5.9 mobility) this worked fine.
Second of all -- I normally ALWAYS have my computer outputting to my TV so I dont have to mess with it. On my DHmodded drivers, I could start a game up while cloned to my TV and basically, I'd see a part of the game on my tv but on my primary laptop LCD it looked normal, I could run any resolution, etc. However I find that with these mobility drivers, whenever I start a game running a resolution higher than 10x7 -- it auto reverts to 10x7 -- even after I exit the game, making me manually change the resolution back. So, long story short, if I'm cloned, I can't run a game higher than 10x7 res.
I know these are somewhat complicated details, but if you have any questions, feel free to ask. They're relatively simple problems, just hard to explain
Sep 4, 2006, 06:58 AM
