Questions about biostar g31-m7 te

barn25 · Nov 19, 2008, 05:44 PM

Hi i recently bought an biostar g31 m7 te and i want to do some basic over clocking and there are a few problem with this borad. 1. When it is turned off and i put the bios config jumper on normal operation it doesnt boot. 2. the options are a little confusing and i would like to hear from anyone as far config options good for oveclocking and settings that are not.

Dyre Straits · Nov 20, 2008, 03:47 AM

Quote:

Originally Posted by barn25

Hi i recently bought an biostar g31 m7 te and i want to do some basic over clocking and there are a few problem with this borad. 1. When it is turned off and i put the bios config jumper on normal operation it doesnt boot. 2. the options are a little confusing and i would like to hear from anyone as far config options good for oveclocking and settings that are not.

First of all, have you installed the latest BIOS for the board? Also, the motherboard drivers?

You can check against what's available here:

BIOSTAR

Now, how do you get around the jumper problem? Are you positive that you're putting the jumper onto the pins properly? Make sure your view is oriented to the view within the manual. (You can also download an updated manual from that link and you need to make sure there wasn't an error printed in the current one you have in front of you.)

Does that board use Award BIOS, or Phoenix, or what? I didn't see that information during a quick glance at the site.

barn25 · Dec 11, 2008, 08:10 PM

well i swapeed out the board for the same one to replace it and the jumper probs went away. Now it uses and AMI award bios. its updated to the latest version. Th eproblems i have now are mainly the ram timing i set. I'm trying to get my ram to go 1:1 when it comes to FSB:RAM divider i have 2GB of crucial 667 memory that can run at 200MHZ . I cant seem to ge t it down to it.

Nov 19, 2008, 05:44 PM	#1
barn25 DriverHeaven Newbie Join Date: May 2008 Posts: 3 Rep Power: 0	Questions about biostar g31-m7 te Hi i recently bought an biostar g31 m7 te and i want to do some basic over clocking and there are a few problem with this borad. 1. When it is turned off and i put the bios config jumper on normal operation it doesnt boot. 2. the options are a little confusing and i would like to hear from anyone as far config options good for oveclocking and settings that are not.

Dec 11, 2008, 08:10 PM	Thread Starter #3
barn25 DriverHeaven Newbie Join Date: May 2008 Posts: 3 Rep Power: 0	Re: Questions about biostar g31-m7 te well i swapeed out the board for the same one to replace it and the jumper probs went away. Now it uses and AMI award bios. its updated to the latest version. Th eproblems i have now are mainly the ram timing i set. I'm trying to get my ram to go 1:1 when it comes to FSB:RAM divider i have 2GB of crucial 667 memory that can run at 200MHZ . I cant seem to ge t it down to it.