|
|||||||
| Motherboards, Networking and Misc Forum Need the newest 4-in-1s? Some nForce drivers? some other driver you need? |
![]() |
|
|
Thread Tools |
|
|
#1 |
|
HardwareHeaven Newbie
Join Date: Sep 2011
Posts: 14
Rep Power: 0 ![]() |
Cooler Master CPU Fan
I'm trying to use a Antec Plus 1080 but the CM fan facing towards the hard drives makes it impossible to add my hard drives because the one cage is being blocked by the CM fan... So can I remove and reinstall the fan or do I need a new case ??
thanks |
|
|
|
|
|
#2 |
|
HardwareHeaven Addict
|
Re: Cooler Master CPU Fan
Are you talking about the cpu cooler with its fan is in the way? If so remove the cpu cooler.......or that fan bottom front ....................
A pic would be good |
|
|
|
|
|
|
|
HardwareHeaven Newbie
Join Date: Sep 2011
Posts: 14
Rep Power: 0 ![]() |
Re: Cooler Master CPU Fan
hm I guess I will need a new case -_-...
If I swap the cpu fan then what I get is nothing pulling the air from the front of the case and three fans (there's two 80mms in the rear area and then the CM fan) pushing out. |
|
|
|
|
|
|
|
HardwareHeaven Newbie
Join Date: Sep 2011
Posts: 14
Rep Power: 0 ![]() |
Re: Cooler Master CPU Fan
[QUOTE=george__;1429282]hm I guess I will need a new case -_-...
@steve isn't that dangerous!? Isn't north to south bad? Last edited by george__; Oct 26, 2011 at 12:47 AM. |
|
|
|
|
|
#5 |
|
HardwareHeaven Addict
|
Re: Cooler Master CPU Fan
I dont have a fan at the front i dont believe in em. I have one up the top as an exaust as hot air risers . A pic would be good
|
|
|
|
|
|
#6 |
|
HardwareHeaven Extreme Member
|
Re: Cooler Master CPU Fan
Ah.. the Antec case that wasn't theirs. I say that because it was a rebranded Chieftec Dragon.
In any case (pun not intended) there's not much you can do about the drive bays as they only come out one way... that is unless you dremmel out the flap (the one that has the side screw in it). Doing that you could undo the lever holding the cage in, slide it bit towards the back, then sideways. I did that with my buddies case, and it worked perfectly (I just upgrade his entire system using that case, and ran into a similar issue with the bottom bay, and his video card). |
|
|
|
![]() |
| Thread Tools | |
|
|