Maxtor's DiamondMax Plus 9 series has been one of the hot favorites when it was first launched sometime ago. Then, it was one of the very first hard drives that boasts using high capacity 80GB platter technology. The drive was largely marketed as Ultra ATA-133 drives with either 2MB or 8MB cache buffer. Users preferred to go for the 8MB buffer version simply because it offered them more performance as compared to most of yesterday's drives that comes with only 2MB of cache.
Since the product has already been introduced, it's only a matter of just implementing a controller board with Serial ATA interface. In the past, users who wanted a Serial ATA interface actually made use of ATA-133 to SATA converters to get these drives running on their SATA-supported motherboards. So, it's not a difficult task to convert their current crop of ATA-133 drives to support the latest SATA standard. In fact, the conversion is so simple and fast that it's just a matter of redesigning the PCB to accomodate an extra chip to convert the natively parallel interface. The chip used here is the same as what was uilized in Western Digital's Raptor and it's based on Marvell's SERDES (serializer-deserializer) solution.
The Maxtor DiamondMax Plus 9 comes in the regular form factor with an interface supporting both SATA and legacy power connectors. The connector layout are plain and simple - nothing too exciting to describe actually. The specifications of the drive are listed in the table below.
Read the review at
HardwareZone.com
Jun 14, 2003, 01:49 AM
