Using Awe NRPN's

Styk · Oct 4, 2003, 02:59 AM

After a week of messing with Creative's drivers on my Audigy card, the only drivers I could get to play sequences using Soundfonts right were the KX Project drivers. So bravo to them.

My question - Do the drivers support AWE NRPN's and if so how to I use them with these drivers?

I am not that familiar with all the DSP effects yet so perhaps I'm just missing something. At any rate I have some sequences that used them previously with a SB Live Value which worked fine. I blew up the SB Live and bought the Audigy. I would presume the Audigy is capable of NRPN's but then knowing Creative maybe not. I just assumed...I know you should never assume.

Anyway any help would be greatly appreciated..

Styk

Daniel Drummond · Oct 4, 2003, 05:17 AM

In the HELP that is bundled with the drivers you'll find a midi specification data sheet. There you can check what commands are supported. And about the effects: you can load up any effects available in KX DSP wndows to use with your soundfonts. By default, reverb and chorus are enabled, but you need to tweak their faders to get them at a higher or lower mix level...

Oct 4, 2003, 02:59 AM	#1
Styk DriverHeaven Newbie Join Date: Oct 2003 Posts: 1 Rep Power: 0	Using Awe NRPN's After a week of messing with Creative's drivers on my Audigy card, the only drivers I could get to play sequences using Soundfonts right were the KX Project drivers. So bravo to them. My question - Do the drivers support AWE NRPN's and if so how to I use them with these drivers? I am not that familiar with all the DSP effects yet so perhaps I'm just missing something. At any rate I have some sequences that used them previously with a SB Live Value which worked fine. I blew up the SB Live and bought the Audigy. I would presume the Audigy is capable of NRPN's but then knowing Creative maybe not. I just assumed...I know you should never assume. Anyway any help would be greatly appreciated.. Styk

Oct 4, 2003, 05:17 AM	#2
Daniel Drummond DriverHeaven Senior Member Join Date: Dec 2002 Location: Brazil Posts: 1,137 Rep Power: 0	In the HELP that is bundled with the drivers you'll find a midi specification data sheet. There you can check what commands are supported. And about the effects: you can load up any effects available in KX DSP wndows to use with your soundfonts. By default, reverb and chorus are enabled, but you need to tweak their faders to get them at a higher or lower mix level... __________________ www.palcomp3.com.br/ed