Antec use a steel design for this case and it features a steel body with plastic front panel. There are three 5.25" bays visible on the front and beneath these a perforated intake area with space for a 12cm intake fan behind.
At the top we find the case connectivity which is made up of 3.5mm audio in/out and 2x USB 3.0. These are centred with the power and reset buttons towards the sides.
The One measures 17.2×8.2×19.2 inches and weighs 10.8lbs.
On the top we can see an exhaust location which is populated by a fan at the factory. Interestingly it is not centred, instead over towards the left edge.
Turning round to look at the sides of the chassis we find that the right side is blank. On the left side we have another fan location again supporting 12cm devices.
The back of the case features a reasonably standard layout. The IO location is at the top left and beside it is a 12cm exhaust location which is populated by a fan at the factory. Beneath these are our PCIe slot covers which are twist to remove other than the top which screws in place and to the right are two water-cooling tube holes, just above the PSU.
Flipping the case on its side we see that four rubber feet lift the case off the floor and there is a removable dust filter for the PSU intake. Also present here is a 12/14cm fan location and four holes for SSD installation.
Unfortunately AdBlockers interfere with the shopping cart process
To continue with the payment process can we ask you to
deactivate your AdBlocking plugin
or to whitelist this site. Then refresh the page
We thank you for your understanding
Hardwareheaven respect you right to employ plugins such as AdBlocker.
We would however ask you to consider whitelisting this site
We do not allow intrusive advertising and all our sponsors supply items
relevant to the content on the site.