ATI Radeon X1200 is it worth modding ?

Discussion in 'Mobility Modder Discussion' started by danny123456, Feb 1, 2014.

Thread Status:
Not open for further replies.
  1. danny123456

    danny123456 New Member

    Jun 2, 2013
    Likes Received:
    Trophy Points:

    I have an Gigabyte GA-MA69GM-S2H motherboard with an integrated Radeon X1200 Graphics card – I use this card as part of a 3 monitor setup, because the motherboard has the integrated card I have to boot the BIOS with the onboard card 1st ( 2 monitors ) and the 2nd card an NVIDIA Quatro FX 560 as the 2nd card ( 1 monitor )

    My question is as follows is it worth modding the X1200's driver – the X1200 is quite limiting, for instance when I stream video via any browser the video is very jerky ? I am running windows XP 32bit so I assume that windows will use the GPU for browser streaming but I am not sure about that and would not know how to change it ( I have 4GB of RAM on my PC ) the X1200 uses 128MB

    Sorry for all this detail but I just want to know if the benefits are worth modding the driver for this onboard X1200 ( I have downloaded all the required bits I need, although I could not find net frame version 2 - I could only find net frame version 3. 5

    I have windows SP3 installed so I doubt I need to reinstall net frame but I would kindly ask for clarification about that and obviously some overall advice.

    Thanks for reading this post.

    Additional details missed out - driver version 8.593.100.0 dated 10/02/2010
    ATI Catalyst Centre 2010 0210 2339 42455
    Last edited: Feb 2, 2014
Thread Status:
Not open for further replies.

Share This Page